Printing VBA-code

Pietje52 · Mar 23rd, 2002, 01:28 PM

When printing VBA-code the modulename and pagenumber is printed in the upmost top leftcorner.
I want to have it printed with some leftmargin and topmargin.
Is this possible? Where can I change the layout of the printing of the programming code?
Can I add pageforms after each procedure?

Thanks in advance,
Ton

GeorgeB · Mar 23rd, 2002, 06:38 PM

Best bet is to copy it off onto a word processor and then print it. Highlight the code, press Ctrl c, open your word processor and press Ctrl v. The code will appear and you can do as you wish.
Good luck.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Mar 23rd, 2002, 01:28 PM	#1
Pietje52 New Member Join Date: Mar 2002 Location: Holland Posts: 8	When printing VBA-code the modulename and pagenumber is printed in the upmost top leftcorner. I want to have it printed with some leftmargin and topmargin. Is this possible? Where can I change the layout of the printing of the programming code? Can I add pageforms after each procedure? Thanks in advance, Ton

Mar 23rd, 2002, 06:38 PM	#2
GeorgeB Board Regular Join Date: Feb 2002 Location: Las Vegas Nevada USA Posts: 240	Best bet is to copy it off onto a word processor and then print it. Highlight the code, press Ctrl c, open your word processor and press Ctrl v. The code will appear and you can do as you wish. Good luck.