Driving around cells whilst in a macro

[Sam40mUK]

Evening All,
I assume this is an easy request.
If I wish to move to the cell on the right or move multiple cells left, what is the correct code?
Many thanks in advance.
S

[Jay Petrulis]

On 2002-04-09 15:45, Sam40mUK wrote:
Evening All,
I assume this is an easy request.
If I wish to move to the cell on the right or move multiple cells left, what is the correct code?
Many thanks in advance.
S

Hi,

Many ways to do this. What exactly do you want?

ActiveCell.Offset(row,col) is a common method.

Post more detals for a more complete answer.

Bye,
Jay

[Sam40mUK]

Hello Jay,
Thanks for the swift response.
Basically I am attempting to End Down to the bottom of a list, then move left two cells and paste a Summary.
The list is a product of a Pivot Table and therefore is of variable length .. hence the End Down and variable nature of left two cells, paste.
I hope this clarifies the situation a little.
Regards
S.

[Jay Petrulis]

On 2002-04-09 15:59, Sam40mUK wrote:
Hello Jay,
Thanks for the swift response.
Basically I am attempting to End Down to the bottom of a list, then move left two cells and paste a Summary.
The list is a product of a Pivot Table and therefore is of variable length .. hence the End Down and variable nature of left two cells, paste.
I hope this clarifies the situation a little.
Regards
S.

Hi,

Range("C2").End(xlDown).Offset(0, -2) = summary value

or

ActiveCell.End(xlDown).Offset(0, -2) = summary value

This requires that this is run with the Active Cell in the correct column.

Not necessarily the best way, though.

Assuming you have only one Pivot Table on the sheet in columns A:E, then you could do something like the following in your code:

-------------
lastrow = Cells(rows.count,"A").end(xlup).row
Cells(lastrow,"Your Column") = Summary
-------------

This finds the last row and places the
summary in the column of your choice. You could also make the column a determined variable as well.

lastcol = Cells(2,256).End(xltoLeft).Column

and reference 2 columns to the left of that

Cells(lastrow + 5, lastcol - 2) = summary val

for example.

HTH,
Jay


[ This Message was edited by: Jay Petrulis on 2002-04-09 16:15 ]

[Sam40mUK]

Cheers Jay,
I will have to give your reply a looking at tomorrow.
Meantime thank you for your effort and help.
S