Array of WorkSheets, CodeModule to Handle each WorkSheet

[VisLord]

I'm trying to create an dynamic array of worksheets, place a commandbutton on each worksheet, write marco code via .Insertlines in a seperate CodeMolule to handle each commandbutton on each worksheet in the array.

All works well, until I .Insertlines and then I loose the reference (scope??) to the main array of worksheets.
So the created Marco doesn't work (no array)

Actual code can be posted...

Help again, guys

[Tom Schreiner]

Where are you declaring your array?

[VisLord]

Hi TsTome,

I'm declaring the array as a global in Module1, "redim"ing as I go along.

Option Explicit
Option Base 1
Dim wS() As Worksheet, uF As VBComponent, pt As Integer
....code....
If pt = 1 Then ReDim wS(pt) Else ReDim Preserve wS(pt)
Sheets.Add after:=Worksheets(Worksheets.Count)
Set wS(pt) = ActiveSheet
....code....

The CodeModule is added in the ThisWorkbook Module

ThisWorkbook.VBProject.VBComponents.Add(1).Name = "cM"

The following sub is ran in Module1 (with NO reference to the array)-

Sub softM()
Dim sSub As CodeModule, l As Integer
Set sSub = ThisWorkbook.VBProject.VBComponents("cM").CodeModule
With sSub
l = .CountOfLines
.InsertLines l + 1, "Sub Scope_" & pt & "()"
.InsertLines l + 2, " setMM(" & pt & ")"
.InsertLines 1 + 3, "End Sub" & Chr(13)
End With
End Sub

After the sub runs the array has no variables.

If I comment out the ".InsertLines" statements, the sub works OK, i.e. I can count the lines and retain the array.

Tks...