Slicers running slow

[halefamily104]

Hello Everyone!

I have searched high and low for a resolution to my slicer issue. When I run my slicer, it takes an average 16 to 20 seconds to filter only one item. I have disabled all of the add ins and removed all conditional formatting. I have even recreated the entire sheet! I am still at a loss on what could be causing my slicer to run so slow! Any ideas or suggestions?



Thanks!

 

[RoryA]

Another gentle reminder:

Cross-posting (posting the same question in more than one forum) is not against our rules, but the method of doing so is covered by #13 of the Forum Rules.

Be sure to follow & read the link at the end of the rule too!

Cross posted at:

UtterAccess.com

www.utteraccess.com

If you have posted the question at more places, please provide links to those as well.

If you do cross-post in the future and also provide links, then there shouldn’t be a problem.

 

[halefamily104]

My apologies. I will make a note of that. Just trying everything to figure out a solution.