bljohnson07
New Member
- Joined
- Dec 17, 2018
- Messages
- 1
Conditional formatting based on a column and TC Name.
Example table below:
<tbody>
</tbody>
So I was giving a R/Y/G fill for the percentages in the "Ave Load" column based on the TC name (because they can be different for each cell) and I was able to do that using a vlookup in the cell value box powerpivot table. I used the TC name and if it was over the max % listed in the table it codes it Red, if it was between the max & min % it is green and anything under the min % is yellow. Worked great.
Moving everything to Power BI I cannot figure out how to do the same and I would like the same table in my reports. I hope I am explaining this well enough so you fine folks can probably tell me I'm over complicating it and help point me in the right direction. Any help is appreciated. Thanks
Example table below:
| TC Name | Project | Ave Load |
| TC1 | 0 | 0% |
| TC2 | 25 | 218% |
| TC3 | 7 | 44% |
| TC4 | 16 | 114% |
<tbody>
</tbody>
So I was giving a R/Y/G fill for the percentages in the "Ave Load" column based on the TC name (because they can be different for each cell) and I was able to do that using a vlookup in the cell value box powerpivot table. I used the TC name and if it was over the max % listed in the table it codes it Red, if it was between the max & min % it is green and anything under the min % is yellow. Worked great.
Moving everything to Power BI I cannot figure out how to do the same and I would like the same table in my reports. I hope I am explaining this well enough so you fine folks can probably tell me I'm over complicating it and help point me in the right direction. Any help is appreciated. Thanks
