savindrasingh
Board Regular
- Joined
- Sep 10, 2009
- Messages
- 183
I am looking for the code to select the visible data after applying a data filter. Actually I know how to select the data after applying the data filter but the issue is I am not able to exclude the header row and give the target range as used (non-blank) rows only!!
I am using below code to Select the Visible rows in the target range:
Problems in this code are:
1) after applying the filter, while selecting the data it is selecting all the rows in given range till last row on the workbook. I need this to select the the data only till the last used row in the given range.
2) It is not possible to provide the address of the first row after we apply the filter since the first row address may change depending on the values in the table.
E.g. 1st time when I am running the macro the first row in the visible filtered data is starting at Cell address A4 and next time when I will run the macro it may be A6
3) The Code is also selecting the 1st row which is a header row. How can we exclude it from selection.
Some one please revert with the solution.
Thanks in advance.
I am using below code to Select the Visible rows in the target range:
Code:
Range("A:p").SpecialCells(xlCellTypeVisible).Select
Problems in this code are:
1) after applying the filter, while selecting the data it is selecting all the rows in given range till last row on the workbook. I need this to select the the data only till the last used row in the given range.
2) It is not possible to provide the address of the first row after we apply the filter since the first row address may change depending on the values in the table.
E.g. 1st time when I am running the macro the first row in the visible filtered data is starting at Cell address A4 and next time when I will run the macro it may be A6
3) The Code is also selecting the 1st row which is a header row. How can we exclude it from selection.
Some one please revert with the solution.
Thanks in advance.