ken_you_not
New Member
- Joined
- Jan 8, 2018
- Messages
- 1
Hello fellow Ex(perts),
Recently, I have created a table that imports dynamic cryptocurrency data from this website:
https://www.bithumb.com/
Since the data I wanted (real-time prices) are constantly updating, I use the "Refresh" tab to keep my data up-to-date. However, I was only able to refresh my data up to a maximum of two times before I run it for the third time where the message, "[DataSource.Error] The Web.Page function didn't finish within timeout of 100 seconds." came out.
Because of that, I have to manually click the "Refresh" tab and instead of waiting for the same message to pop out, I cancel the "Refresh" by clicking on to an option at the bottom left corner of the spreadsheet that says something like, "Click here to cancel". After doing so, I was able to "Refresh" my table again, but only for TWO times
I have spent about 2 weeks trying to find a solution to it, but a lot of solution isn't that direct, plus it requires a pretty considerable amount of programming knowledge to understand it. Are there any solutions you guys think would be able to solve what I'm facing without relating much to the code itself?
I actually tried to record a macro to refresh the data twice, and then finally click on the cancel tab, but the macro couldn't register my last step, and I'm stuck..
SO PLEASE, ANYONE HELP THIS PATHETIC SOUL.
Recently, I have created a table that imports dynamic cryptocurrency data from this website:
https://www.bithumb.com/
Since the data I wanted (real-time prices) are constantly updating, I use the "Refresh" tab to keep my data up-to-date. However, I was only able to refresh my data up to a maximum of two times before I run it for the third time where the message, "[DataSource.Error] The Web.Page function didn't finish within timeout of 100 seconds." came out.
Because of that, I have to manually click the "Refresh" tab and instead of waiting for the same message to pop out, I cancel the "Refresh" by clicking on to an option at the bottom left corner of the spreadsheet that says something like, "Click here to cancel". After doing so, I was able to "Refresh" my table again, but only for TWO times
I have spent about 2 weeks trying to find a solution to it, but a lot of solution isn't that direct, plus it requires a pretty considerable amount of programming knowledge to understand it. Are there any solutions you guys think would be able to solve what I'm facing without relating much to the code itself?
I actually tried to record a macro to refresh the data twice, and then finally click on the cancel tab, but the macro couldn't register my last step, and I'm stuck..
SO PLEASE, ANYONE HELP THIS PATHETIC SOUL.
